1. A dedicated person must be responsible for preparing polymer mortar to ensure the mixing quality. Open the lid of the bucket by rotating it counterclockwise, and use a stirrer or other tools to re-stir the adhesive to avoid separation of the adhesive. Stir appropriately to avoid quality problems.
2. Cut in a clean and flat place. The cutting must be accurate. The cut mesh must be rolled up. Folding and stepping are not allowed. Make a reinforcement layer at the sun corner of the building. The reinforcement layer should be attached to the innermost side, 150mm on each side. When applying the first coat of polymer mortar, the EPS board surface should be kept dry, and harmful substances or impurities in the board cotton should be removed.
3. At the four corners of the door and window, after the standard net is applied, add a piece of 200mm×300mm standard net on the four corners of the door and window, place it at an angle of 90 degrees to the bisector of the window corner, and stick it on the outermost side for reinforcement; Add a piece of mesh 200mm long and standard width to the window at the inner corner, and attach it to the outermost side. Below the first-floor window sill, to prevent damage caused by impact, the reinforced mesh should be installed first, and then the standard mesh should be installed. Strengthen the connection between mesh and cloth.
4. Protective layer after construction.
